1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Howard Eisenhauer's Recent Activity

  1. Howard Eisenhauer replied to the thread 67 Hubcaps, Ss Or Chrome Plated?.

    Do a little polishing on the back side where it won't show & see what happens.

    Apr 22, 2024 at 1:26 PM

  2. Howard Eisenhauer replied to the thread Dana 300 Or Not??.

    How's the output of the T98 configured? IIRC the M715 used a divorced xfer case & does not adapt well/easily to an attached case.

    Apr 22, 2024 at 1:07 PM

  3. Howard Eisenhauer liked maurywhurt's post in the thread Fan Blade Question.

    I installed an OEM Jeep 7-blade fan on my Dauntless last year, and it pulls a great deal more air and cools noticeably better than the...

    Apr 21, 2024 at 6:30 PM

  4. Howard Eisenhauer replied to the thread Re-sealing D18 Rear Output Shaft.

    Actually if you split the felt into two you can get one of the halves in with the two FM seals. Not sure if it actually helps anything...

    Apr 21, 2024 at 1:26 AM

  5. Howard Eisenhauer attached a file to the thread Re-sealing D18 Rear Output Shaft.

    If you go the double seal route again (much recommended) these are the ones you want- [ATTACH] How's the surface of the output yoke?...

    sm_D18 Rebuild dual lip seal_1.jpg Apr 20, 2024 at 10:39 PM

  6. Howard Eisenhauer liked DouglasM's post in the thread Cj5-head Gasket Or Cracked Block?.

    I owe you all an update! Curiously enough the block was not cracked nor did the head gasket have any obvious failure points but...

    Apr 18, 2024 at 10:14 PM

  7. Howard Eisenhauer replied to the thread The Official "What The Heck Is This?" Thread.

    That's where the oil pressure sensor goes, looks like someone replaced the idiot light with a gauge & now the hose is missing. I'm...

    Apr 18, 2024 at 4:00 PM

  8. Howard Eisenhauer replied to the thread Trouble Bleeding Rear Brakes.

    Other side bleeds ok? Can you get fluid at the flex hose over the pumpkin?

    Apr 17, 2024 at 7:35 PM

  9. Howard Eisenhauer replied to the thread Logan 922 Lathe.

    Any lathe is better than no lathe :D Is it home yet???

    Apr 17, 2024 at 4:47 PM

  10. Howard Eisenhauer attached a file to the thread Should I Buy An Oil Temp Gauge?.

    [ATTACH]

    upload_2024-4-17_12-39-20.jpeg Apr 17, 2024 at 11:39 AM
Show older items
New Posts