It was probably a 225 dauntless Odd fire, V6..... a very good engine, with high torque and 155 hp......
Hi, I sent you a PM... I have a good Distributor for you 1969 Dauntless odd fire...
I just sent you a PM ... I have one just like your original one ... for sale.. cheap...
Thank you for your input... I will look for the BOM... I was told by the guy that built it ... that the tranny (T-90), transfer case, D-18 and the...
Here are a few photos of a 1950 jeep front axle mounted in a 1928 Model A Truck..... it has a Dana 23 rear axle... I was told they are both full...
53 3b.... One way to test if your throw out bearing lever will dis-engage the clutch at all.. is , to disconnect the cable, use a small hydraulic...
Ok thanks... mine is about 1/16" thick... I was just wondering if I had the right one... it sounds like I do... thanks again... Sunny
What I am wondering is..... I have been missing a gasket on my recently installed 2G carb....??? when it was on and running, I sprayed carb...
Well.... I put my Jeep up for sale today... ( it is also posted in Early CJ5 classifieds) [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]...
Ok... thanks for the input.... I hear you all.... and I plan to take it out onto better roads next week and try driving it differently... and then...
OK... Thanks again... I really appreciate all your input........ You are probably right about me shifting too early and at too slow of speed at...
OK , thank you for all these ideas... So the way I tested this today, was.... I start out in 1st, accelerate rapidly, winding it up to about 3,000...
Tires are Not Big..... 235/15" 29 " tall
Separate names with a comma.