Unfortunately, most all of the aftermarket rubber parts are made in China. They haven't seemed to have mastered the art of rubber compounding and...
Now you tell me! I had a major leak out the rear manifold gasket (after R&R the intake) and this is what I found (see pix). Looks like I installed...
+Or use some Loctite
Me too. Studs are much easier.
Not sure I understand what you are looking at. Here's the core plugs in my 304. [img]
This might help you. I had the same problem understanding it. Guess that's why the call it 'odd'. https://archive.ph/mS6ch
Sent you a PM for the Dizzy.
Lots of transmission info Here https://www.novak-adapt.com/knowledge/transmissions/manual
Just throwing this out there, In 1976 bought a 76' K5 Blazer new, and it came from the factory with a "steering stabilizer". After 50-60K miles,...
Got the float problem fixed and carb back on the truck. Runs like a top, thanks for all the help.
I believe I have found the problem. The wire retainer for the needle gets wedged between the float and the pivot rod. It stops it from moving up...
It's a stock mechanical fuel pump. I've tried a couple different floats and it keeps doing the same thing. I flipped the cover over and the float...
Yes, somehow I remembered the discharge CV ball. It seems like I have a float, needle/seat problem. With the engine running, the gas pours out of...
I rebuilt my 2G, and now it seems to leak out the accelerator pump squirter. What did I do wrong?
Separate names with a comma.