Any one ever run a sway bar on the rear axle of an intermediate? Can’t say I have ever seen a factory one.
Well, looks like my 304 will be needing a new timing chain. Checked the back lash at the distributor. I am right at the limit. The set in there...
Just wondering if anyone here runs a dual alternator setup on their jeep with an electric winch. If so how about some details please.
Who is running ''Auto meter" 2 1/16 inch gauges that would have an opinion. I have not seen them in person, They look like really nice in the...
Ok, question for all you folks who paint their small parts when doing reassembly work. Parts like bumpers, seat frames, shift leavers, mirrors and...
My 74 with the 304 V-8 with the factory distributor uses a ''resistance wire'' in the wiring harness from the firewall connector plug to the +...
Well I have all but given up on finding a good used windshield frame for my intermediate 74. looked at 4 used ones for sale around and none of...
I was just doing some research on installing my new YJ springs, poly bushings and hangers. I read something about the new poly bushings needing a...
I have been researching which welding helmet to buy. I see that I certainly need one with auto darkening. I also see most of the better helmets...
Just looking at my 74 windshield frame and wondering what one is to do prevent further rust on the inside of the tube where there is no access for...
Just thinking about the skid plate and cross member on my 74. It is easy to bend if you hang it on something. Have any of you ever tried using a...
The man up the street from my brother has these wheels and would sell them. He said he thought they are from an older model jeep but was not sure....
After reading the post by ''rusty72cj5'' I was just wondering about the diagram of the coolant temp override switch. The switch simply changes the...
I have acquired a dana 30 narrow track axle. It was in a 73 cj5 what was involved in a fairly bad frontal collision. My question is can anyone...
There seems to be a lot of talk now and then about upgrading to better alternators. I am thinking of going to a 10si or12si delco have not seen...
I would like a good respirator that is comfortable and has replaceable filters suitable for use under a sand blasting hood. Can someone recommend...
Has anyone ever tried to separate the double layer panels on the rear half of the fenders? There seams to be corrosion between them forcing them...
Well I got the cj5 started up. It has been sitting several years in my shop. I completly re built the carb, new points and cond, new dist cap and...
Are all factory AMC 401 engines equiped with a 4-barrell carb? or did some of them have 2-barrell carbs. I found a mid 70's j-20 truck that is...
Well I bought a used eaton brand air compressor. Was from an estate sale. it ts a big one with a 120 gallon tank, 3 cyl two stage compressor,and...
Separate names with a comma.