Was planning on swing style. Going to check this afternoon how much room I have between the floor and my flat skid plate. I think the frame and...
I finally got my new frame built so I have my body fit to the new frame, and need to figure out my brake and clutch pedals figured out. Thinking...
Just am update, I ordered the ome cs019R springs for the front of my jeep. Will get some pictures and measurements of them when they show up later...
@jonnyc1999, the S10 springs worked great. Great (almost to much) flex. Got way better traction with them then the stock 12 pack (being...
For what its worth I am building spring sliders to replace all 4 shackles and the front springs will have the slider in the rear instead of up...
I have what used to be a 66 jeep CJ5. I now have built a 2x4x3/16 frame, and am at the point that I need to decide on what springs to use. I had...
An update. Made up both rails this last weekend. did a TON of measuring and now need to make some decisions. My current wheel base was only...
Went and picked up the 2x4x3/16 tube yesterday. Way better price to buy at 24' lengths. So needed up with 48' for right around $200. After two...
@oddfirejeeper, thanks. The stock body was totally shot. The only problem is that they deflect only about 20% of the flying mud and water! But I...
Well that didn't work at all for posting photos.
[IMG] [IMG] [IMG]
Thanks guys. Yeah today I did some more tearing down and a Bunch of measuring and I agree that I will step up in the front and rear now. I want to...
I can find bits and pieces of other peoples builds, but still have some questions. I plan to use 2x4x3/16 steel tube. My jeep i started building...
I actually had elkorn driveshaft build my driveshaft for my bronco II. Now I run regular u-joints, and no more of that axle CV shaft type crap...
I will call around to local shops first. Well Corveep, I am glad to see I am not the only one that is running a Stubby little driveshaft. Hey...
From your guys experiance, where is the best place to get driveshafts made? I am in need of them for my jeep. Right now I just have the old ones...
Thanks a lot. Yeah i need to get some more newer pitures up becouse that one of the 350 is not even the motor I have in there now. That one...
No i would just toss it out. When you do put my address on it and I will send you the money for shipping. Zach
lots of good points here so far. I know when I run a mig (with argon) I always push the weld and run a circle pattern. I am a state certified...
I just thought I would fill yall in that I now have my freshly rebuilt ( 30 over) buick 350 in my jeep and running like a champ. what a pain it...
Separate names with a comma.