These are Power Kings I was running on my 64. Little road noise...of course when you are only doing 37 mph....
Ok guys this is the first attempt from one of my sources...not a fan...especially the "J" and the "e" are not correct. As soon as I get a proof...
What are the dimensions of the Approved Equipment decal? I may have source that can make them for everyone.
I am interested in the large Jeep emblem from the DJ. I also sent you a PM on the 2A page forum. Thanks, Chris.
Hi Jim, out of curiosity do you still have the grille and or headlight buckets? If so I might be interested in them. Thanks, Chris
So I have heard everthing from toothpaste to sand paper but what really gets the plastic parking light/turn signal lens covers looking like new...
Great info. Many thanks.
So a friend ran across a jeep with data plates verifying the jeep was made in Windsor Ontario. Anything special about this? I assume there were...
So I have a plexiglass replacement and seal ready to be installed on my CJ5 hard top. My question is what goes first? Does the seal go on the...
Well tell me what you think. I think it gives the jeep at little added demension... [IMG] [IMG]
I saw (seen) one once from the great state of Oregon that no doubt was a logger of some sorts and had made a bracket to hold his David Bradley...
Just the info I needed, thanks!
Ok guys so at this point I have to admit my lack of early cj knowledge. I titled this post bad alternator and the whole time I have a...
Sure. Are you using the one in the rafters? Thanks!
Hello, was wondering if the original roof rack designed for the hard top on a Commando would fit on a CJ5 hardtop...I like the looks of these and...
Great suggestions! I will have time to check voltage later this week and will post results. Cables and terminals are fine. This Friday is jeep...
So last week I pulled my battery out for a day to use on another vehicle. One day after putting it back in the charge was dead. I was able to jump...
Not sure. There are no markings on them at all...???
I purchased these this weekend from a junked 70 CJ5. I assume they are part of the soft top assembly. Not certain I am going to try and put a soft...
I will take some pics tomorrow and post up. I am uncertain of the make of the hardtop. I will also look at the hinges. Not sure I can gain 1/2...
Separate names with a comma.