Let me state first that I normally avoid HF for anything that are not a “one and done” or simple use (tarps, straps,…) items. However, I just...
Couple questions based on last post: I am going to replace my fuel pump. currently have a double action pump but don't use vacuum wipers on the...
I have had my Jeep for 20+ years and have never noticed gas boiling in the tank until the last year and it has started acting up (dies) when it is...
Ok so my 60 Cj5 has the original spring (9 rear / 7 front) the frame is good but the springs have seen better days (Jeep Lean) Not really...
Ok, so it was finally nice enough to break out the Jeep last weekend. went about 1/2 a block and noticed the temp gauge was almost to the hot...
so I have the original starter switch on my 60. I have been worried that the keys are very worn and the worst happened yesterday. put the key in...
Not sure what is happening here. Jeep seems to be running fine but anytime I have it out for long, it will start dieing on me. It always seems...
Ok, now that the 60 is running well again, it is time to start thinking about what is next..... It still has it's original springs (7 pack in...
trying to figure out why my left rear directional is not working. tracked it to a splice under the hood. when I disconnect the joint and put the...
Ok so I have a petronics (sp???) unit under the distributor cap and when I was setting the timing on the jeep as part of a tune up, I noticed that...
F134 with Solex carb and electronic ignition. Just did a tune up. · Checked Valves · Set timing · Replaced fuel line that had a bit of a...
about to buy a JL Sport S for my son. HOWEVER, I have an issue with the stock tires. I cant stand a Jeep with street tires and mud tires are...
Took the CJ5 (F-head) out for a ride today. After driving for 30 minutes (last 5 up a mountain), I turned it off and noticed a gurgling sound...
I have a 1960 CJ5 with F-head (good condition), T90, 5.38s, 11" brakes, Elect ignition, and 31" tires. Looking for options to make it a better...
Trying to figure a way to install a radio in the glovebox opening on my 60 CJ5. the dash is clean so cutting a hole is not an option and I don't...
I have a little project idea that I have been tossing around in my head. I have a solid black bikini top on my 60 but I really perfer to have no...
From the front bumper to the back of the hitch. Trying to see if it is going to work in a garage with other stuff?
My fuel pump has started leaking. There is a small hole in a square about half way down on the pump that the gas is coming out of. (it is the...
has anyone here done any aluminum welding? What type of MIG setup would you recommend for 3/16 plate or less. Specific model and brand would...
This is the weekend, the family is gone and I am going to sandblast the hardtop I bought 1 1/2 years ago. Then I will have to work on it to have...
Separate names with a comma.