https://www.facebook.com/marketplace/item/329390903022225/?ref=search&referral_code=null&referral_story_type=post&tracking=browse_serp%3A3c7ab20a-a...
Guys, as I get ready to get back to the '63 build I need to see if I can get the stock height for the CJ5 B and C pillars. I put cages in and...
Guys - looking at a possible change in paint. Have the base done in the Van Sickle Tractor Primer and Paint. Its a "Alkyd, Oil Based Enamel" -...
OK - so I've finally got a Lathe and Mill coming now that I'm not moving to Utah. Its been - eh, lets just say way too long since I've used these...
With all the body work I've been doing and needing to make some good floor pans, Tranny/Tcase Covers, I'm looking at this Eastwood Setup. Anyone...
I originally did this in my '62 build, but have had folks asking about it. I have copied the posts here for folks as it will be easier to find in...
I'm finally going to get serious on building the '62 CJ5 and thought I would put what's left to do in a thread (well, most of it is left to do)....
SWAG Off Road Just a reminder for folks like me that use these folks. I forget they have ONE sale a year - Cyber MONDAY ONLY (updated from last...
So - it looks like Summit has entered the fray with their MAX-efi 500 Fuel Injection System. It looks a lot like the Gen 1 EZ-EFI I run on my two...
Looks like they sold the tool line. Wonder if that is good or bad for home folks wanting good tools. Sears to sell Craftsman for $900 million as...
So, I thought I would post a couple pics of what I installed in the shop last weekend. So far, very happy with it and it looks like it will do...
So, I got a good set of bits years ago when Dad died with some good spares, Drill Dr keeps them nice and sharp when I need them too. Problem - I...
Hey guys - Buddy needs a lift on his 99 TJ - what are the best ones out to be recommended? I have been looking at the standard BDS, Skyjacker,...
Guys, I want to see if anyone has any 'hands on' experience with this as mine is just theory from reading. Jason is looking to get the lower gear...
OK - I think I had the pplate torqued too tight, but can not find anything with firm numbers. When I put the setup in, I used the specs for the...
Guys - I finally found my manuals for a set of Detriot Lockers (NoSpin) that I had sold years ago to Clint and Chuck on the site. Unknown to me,...
Guys - Working on a T18 for my niece's rig - got the rebuild and input shaft swap done this weekend, but it looks like the rear adaptor does not...
Guys - I ordered a short shaft kit for a T18 - I thougth it was supposed to have the front bearing retainer machined for a GM TO, but that's not...
Guys - I had a local here tell me that there is a clutch kit (like LUK or such) that will go with a T18 4 speed and the Dauntless. I am not aware...
Guys - lots of discussion on Alternators lately and the 1 vs 3 wire setups. One thing I would like to see how other folk ID the output of the...
Separate names with a comma.