OK, Now I suppose you will be wearing a flowerpot on your head. It's gonna take a while to get that song out of my head now. Dave
I have always thought that soda blasting required neutralizing because a base is just about as bad as an acid. When I epoxied my garage floor, I...
Very Interesting, you are really learning a lot. Got an M38A1 engine that I had bored and honed, the machined head, and the stuff to assemble it...
Had a 5 hp compressor with a 30 gal tank. It couldn't keep up. Saving that for the wood shop I plan to build. The Quincy 5 Hp has 23 CFM and it...
Drove the 64 M38A1 4 or 5 trips around the block just to keep it going. Cranked the 53 and let it warm up. Got the king pin bearings and races for...
Looking good. I like the patina on the other M38A1. Looks like a lot of fun to drive. Dave
A fresh air supplied respirator is the only way I would do it again. I did use an approved respirator with new filters and a hood. Dave
Wear a respirator and proper protective equipment. I used to sand blast my tubs with a pressure pot sand blaster and the air pressure set at 85...
Your progress looks good. That engine is shaping up. Lots of energy is for sure. My brother has one named "Mr. Bones." Great dog always has...
A master of many talents. You guys go good work. Dave
I think it's a salad Jeep from several different salads. Lots of extra sheet metal on it. Dave
Not sure if it started as a military Jeep or civilian. Has too many modifications on it to tell. With that front bumper and winch it should do a...
Nice. That looks very capable, ready for the trails. Dave
1967CJ5A came by and we worked on the M38A1's all day on Sat. New tie rod ends on the 53 and did the alignment. Turned out the new wires I made...
That is a nice 416 trailer. Not bad shape at all. Dave
I always like when I make a perfect flare and the fitting is still on the bench. Just like soldering the connection and the heat shrink isn't on...
I'll try it, we were going to do some more carb tuning. We'll be working on them on Saturday. Dave
Those look pretty good. I have seen a lot of these trucks with Cummins Diesel engine conversions. I have heard that the original engine was...
Getting ready for Spring. Saturday drove the 64 USMC around, got to change the oil and filter, grease the chassis and get ready for the season....
Got an old Toyota pick-up with the 22R. Was always going to do a 4.3 swap, but a timing chain, valve seals and weber carb is all I've had to do to...
Separate names with a comma.