This Surrey Gala Jeep, '59 DJ3A, was on display at the AACA Fall Regional Meet at Hershey PA. [img] [img] Offered by Dragone Classic Motorcars @...
In the Ford Model A world there is a guy in Northern California that has some wheels that were on a rolling Model A chassis. They look like Jeep...
Not mine,...
Not mine, just passing it along. Marketplace - 1953 Bantam BT3-C | Facebook
After much research, chin pulling, and head scratching I have decided to build a set of Bows for my CJ6 which will support a summer top. As a...
I have been doing some research on summer tops for my CJ6. I would buy a Tiger Top if it were available in white (me and many others). So I am...
Found this diagram on the Vintage Ford Forum. Using a Vacuum gauge to fine tune the timing and carb's on my Dauntless got her running very well....
Anyone have a solution for storage of tap and die tools? I have a big mess in my tool chest and looking to clean it up. [img] The cheapo set I...
I am rebuilding my Dana 18, mostly because I am tired of pans and cardboard under the jeep. Last season I leaked out about a pint of Gear Oil....
I have an original fan, 5 blade for my 225 V6, but a couple of the blades are bent. Thoughts on straighten the blades? [IMG]
Working on a '67 225 Dauntless, the intake manifold has two ports (5/16"holes) that bring exhaust to the base of the carburetor. The guy that...
Been chasing problems with my Dauntless for several months. Runs a bit and then just dies, like is out of gas. Started with electrical, new...
Got my Heater Delete panel installed, yea!! But, would have been used to plug the nipple on the water pump that goes to the heater? This is on a...
Just picked this up in Maine. Looks unmolested, will know more tomorrow in the sunshine. [IMG] Original hitch, kickstand, license plate...
Looking for placement guidance for Fairlead. I am mounting a Koenig 100 winch and planning on pulling from the bottom of the spool, is that...
Getting ready to finally fix and install my Winch. I made this mock up a few years ago... Koenig 100 Winch Mount and U-joints mockup Anybody...
Well this is a much discussed topic, however I have a question. How do you tell if a gauge is blown? When I do the Ohm checks against this...
having vapor lock on my 67 CJ 6. Need to hook up the return line. However the tank doesn't have the fitting on the top and the float and sender...
Installed my rear drive shaft... I think it is too long. I was able to get it in, however I have no more "collapse" on the drive shaft. Here are...
Anybody know what this bracket is for? It is mounted in the center of the inside of the Windshield. Has a square hole in the center. [IMG]...
Separate names with a comma.