I vote not a chance. Just drill and tap it. You can try heat and weld a nut on but I wouldnt chance breaking off an ez out no way. You are taking...
I think it gets more liquid the hotter it gets so maybe it wicks in a bit then. After its too late
Yeah I have some of that old stuff its like thick paste. Id much rather use new stuff it moves around better. I usually do wheel bearings once...
Well if you put the thermostat in upside down it will push it open and take forever to heat up.
New upgrade, that possibly nobody ever wanted! | ECJ5 (earlycj5.com) Some info on the fan clutch. Some dont have any room for one. The rad is...
And the key goes tapered end in first and tword the shaft to correspond with the cut on the axle. But it isnt that hard to pull the axle and check...
I would drill it too small and wallow it out till it fits good. Its not a critical thing anyway. Are you worried about balance? How fast do you...
Yesterday I swapped the horn for an old Ah-Ooga horn. Just for kicks its very funny! And today I installed the power-lok. I tested the breakaway...
I put an ahh-ooga horn on my fc. Its fun cant wait to honk at people now. I have a power-lok for it Im probably going to put in this week. I have...
I have like 4 sets of channels made I will sell. I also make the upper hinges but dont have any at the ready but I have time maybe this week ill...
Second test ride today works pretty good had a fuel leak pulled the tank off to fix. I guess i need to tighten the chain aswell. Very happy with...
When I first rebuilt my 2a the cork seal for the sender disintegrated and kept clogging the line. I had to stop all the time and take line off the...
I think id start by replacing the oil pump. Nothing to loose. What oil are you running?
Nice my neighbor has one he had since he was a kid in the 70s his sone rode it and now he restored it for his grandkid. He couldnt get it running...
Almost done just have to finish the tank mounting and do some decals.
Only put one on if you need it. It makes the steering harder offroad. But if it whips the steering wheel out of your hands alot from hitting stuff...
They do tend to loosen up I suggest good lock washers and lock tite. Im not a torque wrench kinda guy
The ridge was so big on my mini i used the grinder to take it off. like 1/16th easily. It should go to the machine shop but aint nobody got time...
My fat bike is almost done. I finished the seat it came out great. I test rode the bike it works good. ow just have to finish the paint job and...
Do you have to anneal the copper gaskets? Often times on small engines they leak because they are too hard. I used a fel-pro on mine after the...
Separate names with a comma.