Its a high mount Buick pump bracket.
While installing my Herm Ford Reverse steering box, I have noticed it is very close to my mechanical fuel pump for my Buick225. I am considering...
I have been working on installing my Herm Reverse Ford steering box on my CJ3B with a NT Dana 30. I ran into a problem with my drag link, but...
I have been planning on using Herm’s Reverse Ford power steering kit on my 3b for some time. While installing today, I found out that the stock...
I have a question that I can not find the answer for. Should by transmission/transfer case be level in the frame (my rear output yoke is down 5...
I would a pair work on a CJ3B? How long are they?
Thanks for the feed back. I will see if I have an issue when I put the tub back on, but I don’t plan to add spacers if I know have to.
I am finishing up my Dana 30 swap and can’t be happier with the way it is turning out. I can see the width difference in between the front and...
I took the extra spacer (???) out tonight and put everything back together. The axle moved enough for me to install the snap ring on both ends....
Thank yo for the quick responses. I think I know what the problem is. My knuckle kit (roller bearings, seal, etc) came with a plastic shim the I...
I am all most done with my dana 30 rebuild/install to replace my dana 27. I have run into a problem trying to get the axel out far enough to...
I need to review my notes, but I believe there are two size races and bearings (OD) based on if the came a Dana 25 or 27. The (ID) spindle size...
Would not have thought of that, great idea.
NickMil, Any way to measure the thickness of the shims and related to degrees?
That is good to hear. I don’t see any damage to the axel, so I should not need them anyway.
Thanks for the information and advice. I will be putting it back together without the shims and see what I end up with. If I need the shims in...
OK, I am starting to put my Dana 30 with drum brakes back together. I broke my cardinal rule of taking photos of everything and find myself in a...
Another D30 parts question? From what I have read on this post and others, I think I have this correctly: All Dana 30 housing are the same All...
Interesting enough, I found a Dana 30 with the large (1-1/8”) disk brakes within a few hours of me for $50. I am torn, as I could grab this axle...
Thank you. I will look it over.
Separate names with a comma.