I don't have baffles in my tank and the Fuel injection pump doesn't like to suck air on inclines or spirited driving... So, what about foam? Is...
I need new tires on my cj2a.. They look fine, but they aren't.. I was coming up a twisting hill on asphalt last week at about 35-40 MPH, back end...
I have an ATV overdrive on my D18. I have about 500 miles on it since I got it used. I use it in direct almost always, but would shift to OD...
Guys, My jeep died driving the other week. Going along, everything is fine, then dies. Pull over, crank, no start. I towed it home. Thought it was...
I used this tool to remove case bearings on my D30....
Before we go any further, I am not building a race car cage, its not going to be CrMo, I dont have the time to Tig weld the thing and it may be...
35 bucks for all shipped in a flat rate box to anywhere.[ATTACH][ATTACH]
I need to change the pinion angle because lift springs and caster angle is wrong. To do this I am taking off my outer C’s. lessons learned.. the...
I'm sick of trying too deal with the transfer case brake.. Yeah, I know some of you have great results. My experience is different. I want easy,...
[ATTACH]
I have a set of drive flanges from a D30 quadratrac hub. Are the dust cap nut covers the same ID as Dana D44 or 41 or AMC 20 hub nut covers? If...
I am somewhat familiar with these https://www.galco.com/acs150-03u-09a8-2-abbi.html but made my own radial phase converter out of a 7.5 HP 3 phase...
I have a 2000 4.3 GM V6 engine in my 48 CJ2a. In the swap I elected to keep the catalytic converter. I have driven it for several months and as...
I decided that I needed a new welding hood. My old3M speedglas...
http://ox-usa.com/product/D30-373-27/ Anyone run one of these? What kind of actuator? Im leaning to the cable, but does it have drawbacks? Thanks.
The fuel pump for my 4.3 is the stock style one that came with my Astro van. I built an in tank holder and it works fine. it makes a lot of noise...
My brand new alternator on my 4.3 Chevy swap wont charge. I have a Howell wiring harness for this swap. It has a wire that says 12Vdc lamp to...
[ATTACH] [ATTACH] Didn’t get the jeep running yesterday, so I built this welding table out of 1/2 plate. It was all going to go in a dumpster....
[ATTACH] [ATTACH] I am attempting to start my 4.3 transplant into my 48cj2a. I have no spark at the plugs. The distributor got moisture inside the...
Finishing up the install of a 2000 4.3 FI chevy engine in my cj2a. If you performed this swap, where did you mount yours?
Separate names with a comma.