The oval duct from fresh air intake to top of heater box is very mouse eaten. Is there a replacement? This part says its fresh air duct but it...
Anyone put an electric choke on toggle switch instead of from ignition? I like to have control of my choke but would rather route some wire than...
Guys My Super Jeep is a resto-mod so no need to beat myself up finding original wheels. I'd be happy to have 15x8 steel wheels of similar...
The lower end of the clutch rod (between pedal and rocker arm) is shot. Its the kind with a ball and socket, wrapped with a rubber dirt shield....
Guys, I think the MC2100 is near perfect carb for Jeeps with 258-304. One occasional error is to install the incorrect gasket for the power...
Is any cutting to inner fender required to use 76+ Fenders on an intermediate?
Were they carriage bolt heads? The ones with heads on top? If so what kept them from spinning? Any better options for resto-mod? 1973 CJ5...
My TSM is at garage with my engine. Figured to connect my hitch and need to drill some holes in cross member. Doea the tombstone shaped thin...
Gents, Where does this sticker belong on an intermediate? Does it belong at all? [ATTACH]
My 73 is missing evap canister and all elements of air injection system. All I have is a roll-over vent valve. Utility of which I question since...
Almost close enough antenna. Telescoping, ball and spring. Auto Select Universal top and side mount antenna. [ATTACH]
Guys Intermediate Renegades have a length of hat channel running across the back top of the solid back panel. What is the distance from top edge...
Lots of creative mods have been performed to our Jeeps, such as junkyard electric cooling fans, disc brakes, axle swaps, etc. Do you guys...
Anyone know how it was made? I see shallow stamped cups for sale. Seem to recall mine may have been solid steel? Been so long since Ive seen it...
Gents Was window shopping for batteries to accessorize with my new alternator and foumd that every size 24 AGM battery had the positive post on...
I vaguely recall the front running lights, tail lights, and reverse lights had a thin foam rubber type gasket between lights and body panel. Does...
Anyone make their own replacement skins for a Whitco or similar top? I’d like to know how it went, what you learned, sequence of fabrication,...
Anyone know if anything goes in the small slots on the edge of this shroud? About to plate over the damaged mounting holes with a flange of...
[ATTACH] How were the aluminum parts treated? Nekkid aluminum? Mine is getting chalky and I dont like it. I'll either do clear, aluminum paint...
Took a chance on $20 Amazon tube and stick kit. Couldnt bring myself to go the premier AMC vendor price for a piece of tubing. Most reports of...
Separate names with a comma.