I've searched, I've researched, I've checked, I've asked... Same Jeep...SBC/32's (for now, 34's later) Am I better off building a 44 front end?...
If you don't want to run a full size Saginaw pump to run the Saginaw style power steering box, a Nissan pump has a remote reservoir, it's fairly...
Right now I have a Tulsa PTO winch on the back of my junk, as well as a Belleview on the front. None the less, the rear winch is more important,...
I need to figure out a spare tire carrier and jerry can holder and hi lift and shovel mount. I'd like to keep my back seat if at all possible. Was...
Searched with no luck in the past, so I'll ask. Are the backing plates on 10" drums the same on a front 27 as a rear 44? I can get most of my...
I've searched.... ;) Not finding what I need. I have a front Ford LP 8 lug 44, a Waggy 44 6 lug, and a EB 44 front with 5 on 5.5 The only...
ever been done? My factory hinge is cracked and weak, plus I like the ability to pull the hood all the way off... Maybe I'm just sick and twisted....
Have a repro sender unit in the Jeep with a plastic float in it. It worked nice for about 4 hours, then the plastic leaked, got full of gas, and...
How do you guys run your Dana 18 OD shifter on the back of an SM420? I'm not seeing how to fabricate one. Pictures please? Thanks
I wanted PS on the Jeep and ended up ditching any Saginaw design. Looked at my buddys EB and liked what he was running. I'll end up with better...
Not really the pedal per se, more less the pivot arm. Seems as though when the V8 went in, it was either have my drive shaft bind up in the tranny...
Which, IMHO, everyone needs. I have $7.21 into the thing right now, and that was for the hardware. The rest is scrap I had laying around or bummed...
Basically, with the SBC swap, I would like to run dual batterys as well. Figure, while I'm in it all, might as well. The reason is, I have a ready...
So far I've made a tank out of one of my rock sliders, and now I need the pump. I figure I can run it off the 283 from a York air compressor....
Not V6, not CJ5's.... I want to see SBC or SBF powered Jeeps specifically of the engine bay. On that, I'm not sure I have room for a stock water...
I've always been told you have to run a tube with old flat fender wheels (Mine are Kelsey Hayes) but that was with bias ply tube type tires. I now...
My NDT's are unzipping, literally, unzipping on the sidewalls. Along with getting the carb fixed (doing that myself) I'd probably getting some new...
Several issues with my Jeep. Let me give you some background. Running a Go-Devil with a Solex carb, Pertronix on in the Auto-lite...
Needed a press and as much as I love HF.....I wanted this to be made in the USoA of US or Foreign material.....So I did. 12 ton harbor freight air...
Now that I have a tube bender I figure next up is a notcher... I have the bearing block and shaft, made that myself as seen here on the JD2:...
Separate names with a comma.