A man on a mission (y)
Yep, she bought me "my own" bottle to use :madwife:
I use the wife's fingernail polish to touch up drilled holes. It is relatively inexpensive, dries fairly quickly and comes with the brush attached...
That is used as a mounting point on my 1970 J/C101 [IMG] [IMG] [IMG]
Here are a couple of charts I lifted from JP magazine that has suggestions / recommendations. [IMG] [img]
Very nice !
The coolant will expand in volume as it heats up, therefore by leaving the level down about 1 1/2" there is space within the radiator for it to...
Nice, I wish you were closer. They should sell quickly.
The master cylinder on my CJ3B is vented to atmosphere by means of a tiny hole in the cap. Because of this design the brake fluid eventually...
X2 on what Pete says. You could also fill the tank with an inert gas such as argon /CO2 from a mig welder before you strike an arc.
X2 template and modify.
I used this and it took to being painted well. This product is thinner / less viscous than the some of the urethane products, which may or may...
Thanks for the responses. It is indeed a gamble buying based on name alone. As stated in the responses, many brand name products are not what they...
What is the current preferred brand of 11" brake shoes you all would recommend? I need to do a complete brake job and the last time I bought new...
Very nice Ken! (y)
This ^^^ X2
Very nice, good job!
Considering that you just recently installed the carburetor you likely used a new base gasket, but just be aware that the gasket is known for...
For another example, I have used this one a a few projects, one of which was used on my CJ3B and I had shortened it about 2 3/4" for use with a...
Use a short piece of thin wall rubber tubing like a windshield washer hose. Use apiece about a 3/4" then cut it lengthwise and trim to fit. The...
Separate names with a comma.