Oh yeah, i saw that post but couldn't find it again. Thanks for the link. I even picked up a second 1/4" npt tap to make a bottom tap because of...
[IMG] The ram assist parts on the right and saturn OD unit and front tube fender kit on the left. Somehow, i need to get all this done in about...
Here is a long over due update. Back in the 2023 epic Colorado trip was my first trip with ARB lockers front and rear. My steering wheel slowly...
"It runs@ 180*-185* running down the road in 100* weather. Once I slow down for in town driving it will kick up to 190*-200*, all depends how fast...
Ive had good luck with moog tres and balljoints. Just make sure you dont accidentally get the oversized moog ball joints unless thats what you...
I used pop rivits. If i painted them black you wouldn't even notice them
Jackson is definitely not the same as a hf hood. Jackson is a very good manufacturer and their hoods and other gear are used a lot in industrial...
The 4cly had 2" od with 1310 yokes front and back. The v6 had same for the rear but the front was different. it was 1 1/4" with smaller yokes....
Im sure the hf hood will work out fine for a hobbyists like most of us on here. I got one of those cheap hf auto hood for my high school welding...
Do the tapping the yoke thing to see if they loosen up a little. Should be a little still but not binding. You can also clamp the joint in a vise...
The pinion nut is a lock nut and is supposed to be replaced after getting removed because the swage wont hold as good as a new nut. I think the...
Yeah, that makes sense. I agree to just run it for awhile too, the jeep is still sitting high on the new springs. When they settle in the drive...
Did you measure the angle at the yokes yet?
Its not so much what angle the actual drive shaft is at but what the angle is at the yokes and that the match each other and that the angle is...
If your tires didn't cause vibration before they probably are not the cause after the lift. I know you want some angle in the shackles but i think...
Im really liking that bumper too.
I saw a recent YouTube video of a faulty out of the box redhead gear. They repaired it under warranty no problem but it still not confidence inspiring
Are you using 4 turn yj boxes? I can only find 3 1/4-1/2 turns. Even the reman boxes are crazy expensive right now. I might see if i can tighten...
If you already have disk brakes and they are in good working condition then i would keep them especially if wheel fitment is a concern. Those GM...
Man, you work fast kyle. i would have rage quit a dozen times from doing that much overhead mig welding in one day. Ngl, im envious of all that...
Separate names with a comma.