Work just like torsion bar suspension.
I couldn't say for 100% certainty, to many years ago.
Guys if you are having this much trouble try this....
You can make your own Micarta relatively easily. Look around YouTube and you will find several videos for it.
Cutting oil is easy to find. Any good plumbing supply that sells iron pipe, even Lowe’s will have it. Ok the old timer in me is speaking. Lard is...
I sharpen drill bits by hand, a lot. But I have and do use a drill doctor occasionally, they are not bad but they do require a learning curve to...
I used one of the screw types for years, it was an American made one, worked well. No experience with harbor freight version. I made one for the...
The originals also had a bolt on cover.
I used my factory 71 dual reservoir to run my front disk brakes and 10" rear drums.
Rebuilding the T14 is easy. That said pay very close attention to the gasket on the front bearing retainer when rebuilding, none of them fit good...
From the MSD instructions remove or disable the trailing points, set the gap on the primary points, the dwell is controlled by the MSD unit...
Not on the oddfire unit, the points act only as a trigger unit, the MSD unit controls the dwell, that’s why I had to remove one set of points from...
MSD boxes fire multiple times when ignited, they also control the dwell. If your not old enough to remember. Multiple Spark Discharge
My old Sears dwell, point, tach meter works fine, no problems, you have something else going on.
When you pull the quill down is there a slot for a drift key to remove the drill chuck arbor? If not then yes the roll pin holds the arbor in the...
A standard drill chuck is held on by the taper only, nothing else is needed. None of my drill chucks have ever had anything else, my big Jacobs...
You don't need the threaded collar at all, drill chucks have locking tapers on them. If yours is slipping off it is damaged in some way. MR Pete...
I have a MK 2 Workstation sharpener, works great. I bought it 2 years ago on sale for $69.95 at the Smokey Mountain Knife works shop....
I totally understand but when I first installed my steering box it was so effortless that I could have cut the wheel off and used the hub to drive...
Super easy to turn is to high of pressure for your needs. You can tailor the pressure to the steering box by changing the pump relief valve.
Separate names with a comma.