A bit more of work, I got a new bronze cartridge case to mate the crankshaft and mainshaft. With all centered in their final position I have to...
I run them. I think it's a good improvement if you want a bit more of articulation without replace leaf springs, arches, etc. It's easy and fast...
After many months stalled my project, today I've been working a bit on it. Past weekend received a new custom cluth adapted to the new VW...
I'm glad you liked, it's just an other different option. It's a shame picture's quality, but were took with an obsolete camera phone mobile. As...
Hi I want to share with you this brake conversion, it's a different option for those who can't find american parts as a donor. Last summer I done...
Now I have a problem, there is not enough room to place the slave cilinder so I must to make a new linkage to actuate the clutch. I'm thinking on...
this is the flyweel and the bellhousing, all mated there is not much room left... [IMG][IMG] [IMG][IMG] the tranny, with the new bellhousing,...
Wuze I have to meet you this summer when the jeep will be ready. I work as faster as I'm able. Well, here a few pictures of the progress...
I do not have many advances, I've had some exams at university and spent last days preparing the xmas things. Tomorrow I'll put some new pictures.
I'll use the slave cylinder to have hidraulic clutch, there is enough space and it passes over the gearbox. Today I've cleaned the bellhousing...
the starter [IMG][IMG] the bellhousing ( I must cut off the diff. with the grinder) [IMG][IMG] [IMG][IMG] [IMG][IMG] [IMG][IMG]
this is the original flywheel with the pressure clutch and clutch (bi-mass type) [IMG][IMG] [IMG][IMG] [IMG][IMG] [IMG][IMG]...
this is the engine [IMG][IMG] [IMG][IMG] mechanical diesel pump [IMG][IMG] turbo & EGR (I'm going to eleminate the EGR ) [IMG][IMG]
I've resolved all the problems. I have used a '94 VW Jetta TD. flywheel, '89 VW passat bellhousing and a '06 Audi A3 TDI starter donor; now I have...
I have already begun working with the engine, I have some problems with the bellhousing- flywheel- starter; but nothing that has no solution......
Hi Eddiem! I'll contact with them. But this shop isn't from in spain it is from Portugal. Look for information here, as I see at pictures is...
Hello and thanks you all for your interest and suggestions. I finally found the engine I wanted, the 1.9TD AAZ with few miles, in perfect...
Hi, look forward to this post. In few days I'm going to start with the swap. http://www.earlycj5.com/forums/showthread.php?t=62415
I have a 2000cc pinto bellhousing at garage; it must be the same model that uses Fivos. If you still need it send me a PM.
I think that put a perkins diesel isn't a good idea. These engines are obsolete, very weighty (unbalance the jeep, specially on downhill), they...
Separate names with a comma.