[ATTACH] Banks 23 guage pin nailer pass. For price it's still working after a month. Can't speak for other stuff,
I run baseboard with 18 guage max finish nailer. I bought for about $100 shoots 2 1/8" I shot dewalts, sencos, Bostitch, Hitachi. My favorite is...
Says the guy who builds custom cabinets and finishes them.
Just want to say those videos are so exciting! To see the sway bar work and how well... looks good!
October 20th is when I’m going to lake county. However in mean time, the thread tarry posted on power steerong woes, my pictures are there. Mine...
Hmm interesting that your power steering reservoir is sitting so low. It looks identical to mine but the steering reservoir sits down real low....
I put mine in the glove box, I made it out of galvanized steel and rivets. This way it has something structural and is fully supported. My...
Some fun stuff: Bellevue winch, comms, something made for the Jeep with a lathe, trail rides! Teardrop or off-road trailer comes to mind. Mini...
Fhoehle: the sun is a real thing. 2/3 if the county basically burned down within the past 5 years. No such thing as a snow season unless it’s...
First of all let me know if we have a thread like this. Fire season is fast approaching for people in California, as I’m sure other states are...
Second picture looks like you made some ford truck shock mounts.
I have one, and built. It’s been a while since I used it. I recall 90 on 1/8” was no problem. I was replicating c channel for a cj5 frame. If...
Time to visit the scrap bins at metal shops. 1” DOM tubing and 3/8 plate is what I used to make mine. DOM goes through the frame and plate....
Shielded gas will be easier for you. Flux core wire can be used but you have to constantly clean it. Use a smaller wire size and practice, watch...
Question: Anyone have opinion on hard fuel lines vs. just running hose? I have the 'addition' rear 15g tank and I'll be putting 'back' the...
Did you make any metal chips yet?
Correct me if I’m wrong but wouldn’t a rotating laser best be used for diging foundation, leveling ground? 2 point laser would best be used for...
I use a glorified magnet (ch hanson stud finder) no phone or batteries required. That way I can find all the metal pipes when im shooting trim :)...
spring loaded punch! brass razor handle would be cool, so is a flame licker engine :) Sooo many possibilities. I would start with basics and...
Lovely work as usual, keep it up! I plan on borrowing a few of your techniques and ideas when I get back to my build.
Separate names with a comma.