Anyone bit the bullet and started to fit a Holley Sniper on a F-134 yet? Looks really promising, but not sure about throttle linkage, and/or...
Does anyone have a source for 15" steel wheels that appear stock for the Metcalf ebrake disc conversion? I think they would require less than 4"...
Gents, I've read up on the Best rear main seal install some. Can one trim to fit it tighter? Metalshaper says they fit loose. I dont see any...
Gents, I ordered NOS t90 case from Walcks, and its covered in rust. Whats the best steps for removal? Bucket of diesel and scrub, vinegar, or...
Gents, I have a 71 without a tailgate, and it has factory paint on it, but it has a heavy plate welded into the tube and I'm unsure if it's...
Gents, I installed my PS pump and it's not really lining up with the closest pully ( to crank.) Can I run one belt from crank, to WP, to PS...
So, I've read a bunch of posts on here about this flip, but still have a few questions, bare with me fella's. Doing this in a Dana 27 with single...
Gents, When adding a M.O.R.E. ps clamp to gear box, am I understanding right that it should be as low as possible? The bearing is in the...
Interested if anyone has bought a roxor sway* bar and installed it on their 27? Justin
Did anyone that has done this conversion run into alignment issues with push rod and pivot arm? I know the 71 is a special case and the bracket...
Fellas, I have combed the interweb and can't even find a picture of what's on my 71, V6, 1 piece bell. It has a 7/16-14 course thread. I found...
Fellas, how much fork travel should the TO bearing have when installed? When my TO bearing is contacting the fingers, I have at least an ince of...
When i tore down my none running 71 v6, t14, d18, I ended up finding a 231 OF. 10.5 diaphragm clutch setup had a roughly 2" overall height...
Fellas, My Valeo clutch came with a steel pilot bushing. Have y'all used these? Or should I look for an all bronze one? Justin
Fellas, Doing my ps conversion I had ordered a crown 999416 arm in advance. Looking at it now I think I'm gonna need a 1-1.5"or possibly 2" drop...
Ok fellas, I started with .065 shim pack and tightened it down gently. No end play. Have y'all seen where you needed more than 1 shim pack to...
I've read a lot on here about guys that go with bigger tires often have rubbing and steering issues. Since i have accepted the fact that i can't...
How tall of a tire are ya'll running? I have a 71 with 231OF, T14, D18, D27, D44F, and am trying to see if i can get away with a lift and...
Is this advisable or not a good idea?
Anyone figured this out?? I've been digging around without much luck. JT
Separate names with a comma.