Years ago, during the height of my Corvair phase, I dragged home a rampside pickup that I had high hopes for. When I finally got to really play...
I did search in the forum for an answer, but can't figure out a way to search that isn't too broad of a search. I want to know if there is a...
[IMG] Saw this on CL. I sent an email to the seller telling him that I want to buy it. Haven't heard back yet. Anybody know what it is....
I have been doing a lot of searching for information regarding wiring my Jeep to coexist with a Chevy engine and TBI. I have found much info but...
Putting my 75 back together and was looking at my pretty ugly green vapor line. I am not sure if it is serviceable but I would have to clean it up...
The engine is a stock 1991 Chevy 350 with TBI. My tank is a new, stock style tank (1975, rear mount tank). I was wondering if anyone has been...
Does anyone know if a vacuum modulator off an AMC TH400 can be swapped onto a GM TH400. I am planning on running a Chevy TH400 on my 75 CJ6. The...
Is the oil pan on a 198 V6 the same as on a 225 V6? Googled the question and still don't know. Thanks.
A little while ago I bought a 46 CJ2a that had been in one ranch family for many, many years. The seller included five rims and old tires that he...
Recently acquired a CJ2a with a rear pto and belt pulley hub. When we got the jeep started we ran the pto for a bit and there was a noticeable...
Do I need the flat steel plate that goes up against the block and gets sandwiched between the block and the bell housing? As you may have...
I just unpacked my rebuilt power steering gear for my 75 Cj6. I bought one from Napa mainly because mine was really ugly and I am not sure of its...
I just pulled what I believe is a Power Lok unit out of mothballs. I bought it quite some time ago and don't remember what it was supposed to...
Are the spring pads on the front axles the same width on 76 and up as the 75 and older axles? I know the springs got wider in 76 but it almost...
While up hunting this weekend I was looking at a cj7 and was impressed by how easy it is to get in and out of due to the extended door opening....
Can anyone tell me if a Delco distributor for an OMC marine engine would work okay in a Jeep? A little while ago I bought a new (or NOS) 225...
Was playing on the net and started looking for a replacement tie rod and ends for the 75 CJ6. One site lead to another and I was seriously...
Does anyone know if there are any similarities between CJ2a and early CJ5 floors? I am mostly curious about the hat channels and where they mount...
So, if...a big if, a person wanted to run an auto in a 75 cj6 behind a 304 (say for instance because none of his three daughters can really drive...
I recently bought a rolling 68 Cj5 chassis mainly because I wanted the Warn overdrive for my 45 GPW. Then I started thinking that it would make...
Separate names with a comma.