Still haven't given up on the build. Just been too many projects other than this going on this year.
Still plugging away at this build when I have time not working on the kid's car, the other kid's house, or taking care of honey do's around the...
Will do, wish we could get fully staffed at work again. Hard getting ambition to do anything at home when all you want to do is sleep. Tomorrow...
Guess it has been a while, and no this thread is not dead. Just over the last 2 years the world has gone nuts. Between being short handed at work...
This year I have not made near as much progress on my build as I have over the last 4-5 years. Earlier in the year I was almost to the point of...
WOW! Didn't realize how long it had been since I updated the build, let alone actually had time to work on it! Finally had a Jeep weekend. Time...
Put my Harbor Freight press on a set of casters. Can move it around the shop now and added height to it. Still seems stable enough it doesn't want...
Ran it pretty much constant last weekend for around 4 hours, long enough the 80 gallon tank itself was warm to the touch. No issues with heat to...
Had some sandblasting to do over the weekend in the cabinet inside the closed shop. So finished up the fresh air intake. Goth inside plumbing...
Myself I'd take the 2 bolts out that hold the plate on the top. Then bend some 10 gauge or even some 1/4" inch plate to cover the top and OEM...
What kind of compressor do you have? Bet if you look close you can figure out a way to put a better filter on it. Might have to unbolt a lot of...
This is the OEM filter on my shop compressor. It is suppose to mount in this position but, when mounted in factory location you cannot access the...
2 things that come to mind about this install. 1st is the washers used to space the booster to the firewall. Think once the final thickness is...
FYI, this build is not dead. Just been busy dealing with other stuff over the last few months!
So, one reason it seems to be taking so long to get this Jeep done is I seem to do stuff twice. Got my steering column fully mounted. Then decided...
Got the pedal mounts pretty much done except for the clamp for the steering column I'll add after the column is in it's final position. Widened it...
Now that the steering column location has been completed I can start on modifying the Roxor clutch and brake pedals to fit. The 3 mounting tabs...
Got the adapter for the ignition switch welded to the dash today and threw in the gauge cluster just to see how it looks. Not sure yet where the...
Finished up the adapter for the ignition switch today. Decided to go with studs welded into the adapter. Had thought about just using pan head...
Made the adapter/spacer for my ignition switch yesterday. Had a good day, made it through all 4 holes without breaking my only #29 drill bit or...
Separate names with a comma.