2X on what Rusty said about the coolant. The head cracked on my 530i BMW, and let glycol into the crankcase. Spun a rod bearing. I will never...
It depends on your transmission/tire setup, too. I have the T-98A tranny with 4.27 gears and the jeep does ok on the road, and very well off-road...
Thanks for the link!!!!! I think I may have most of the pieces from what I see in the directions. If not, I can make the ones I need.
Mine appears to be the snap type, but the pieces have zippers, so I think I will have to go on their site and look. Last glance, it appears they...
I inherited a Bestop top with my CJ-5 from the previous owner. The other day, I decided to see if I could put it together -- no instructions, so...
At least your starter didn't end up like mine. The bendix didn't disengage, so it was spinning with the engine at a hugely stepped up ratio. If...
10X on what Daryl said above....
I put 2.5 " lift on mine with 31" tires and it seems to be the ideal situation with the 134F, but I also changed the carburetion (see below). The...
[ATTACH] [ATTACH] That's why I added hanging pedals, a vacuum booster and a dual reservoir master cylinder. My brakes work great now, even...
Glenn, what was the question? I am interested...
The short one in the front, always. Just did mine and they work great, but the vacuum assist I installed sure helps to stop the 31's better.
My '62 F-134 has 4.27 gears in it. Dana 44 Powr-Lok in back and Dana 25 regular diff in front.
Every time I have my Jeep revved up a bit, it reminds me of the days of MASH when one would hear the Jeeps come roaring into camp. Definitely a...
Hello all!!! I have been doing a lot of testing at the new Apple AC2 site in Sunnyvale, CA, and have had little to no time to be in here. Good...
1960, you are right, and one some models it was for the horn which was mounted on the fender... We had a 6000 lb rough terrain forklift that...
I can relate. I can crank mine way down and it will still run without missing a beat, but you can feel it every time a piston fires. It really...
Straight out of an FSM. I will see if I can find it again.
Suggested idle speed for an F-134 is 900 rpm, which is close to 20% of redline. I have an alternator on mine and it will keep the voltage good at...
Do you have a lift kit installed on your jeep? I have a '62 CJ-5 with a T-98 and a 2.5" lift, and the angle of my driveshaft is much larger than...
Fokker A Fluke 87 multimeter will give you the choice of an audible beep or just straight resistance measurements. I have three of them which I...
Separate names with a comma.