“This vehicle has no significant damage or problems.” :lol:
Price point wasn’t mentioned. :D
https://www.warn.com/125x38-replacement-spydura-synthetic-rope-102343
That’s awesome
+1 The splines on a super duty’s sector shaft are massive. Where did it come from?
Imitation is the finest form of flattery?
I’ve been having a rough idle issue. I tore into the idle air control valve to see if it was clean and working as it should. During the tear down,...
Don’t cheap out when it comes to your vision. I just bought another one of these the other day through work. Best bang for the buck from a very...
[IMG]
These were my first two thoughts
Even if it was an early 44, I’d pass. They don’t have much going for them.
I have a fake account with a fake name, fake address, fake birthday and zero friends. Works just fine for marketplace.
Everything. But mainly a well-lit single side shot showing the rear, the driveshaft, and t-case would help everyone see what’s going on. It’ll...
A picture would really help.
You could probably find a used/decent/correct frame for around the same price as a set of good wiper motors. Try a Want To Buy (or Want To Trade?)...
I just don’t understand how they can go from cutting parts out on a CNC laser, to then assembling those parts on a sheet of cardboard with hand...
I saw the one shot of the trans tunnel and thought, “Gosh, that looks like it was formed by a guy with a hammer.” Two scenes later, there’s a guy...
Intermediates had bad angles to begin with (due to the Dana 20 t-case), but 2.5” lift shouldn’t put it in the impossible range. Take out the 8°(!)...
Jeez! A 3/4” cover! That’s a lot of unsprung weight. :p
That’s a push/pull box from a Chevy truck. (The arm moves front/back and connects to the DS knuckle.) The pitman arm doesn’t use the same splined...
Separate names with a comma.