Been working on a shroud for my cj5 V6. The one pictured is my prototype and made from 3/16 paneling glued and screwed. Hopefully I will refine...
I have resisted in the past, but I'm getting older and this was probably my last chance to try this. I'm rebuilding my T90 shift tower, putting...
I'm looking for a t90 shift tower rebuild guide. I'm looking for a t90 shift tower rebuild procedure. I have searched the forums but only found...
I'm finally back working on my jeep. I bought and installed a HERM rebuilt T90 transmission. My first question is that when shifting, the...
After studying the Novak Research clutch info I know the importance of the clutch fork RATO in setting up a clutch system. They say one should...
I installed a Herm built T86 coverted to T90 transmission in my CJ5. 225, but now having shifting problems. I believe my cutch is working...
I know! Topic has been covered to nauseum. BUT there is no decisive picture showing where the #1 wire should go on the cap. Pictures and links...
Hey team, Been looking but cant find the number of needle bearings on a 1 1/4 inch intermediate shaft in a d18 transfer case. I know some knows...
I have been looking for rick stivers D18 transfer case rebuild video. I find some parts of it but not all of them on utube. is there a link or...
I have lost contact with Herm the overdrive guy. Was talking to him almost daily about stuff. Don't get a reply now and the phone listed on the...
I'm inspecting my D18 parts to see what I need to order beside the rebuild kit. As far as the splined shafts are concerned at what point...
Going to do some jeep transmission and transfer case rebuilding. Looking for recommendations for the right size Arbor Press to do this type of...
1968, V6 225 ODD FIRE CJ5 WITH T86 TRANSMISSION Gears grind when trying to shift into first and reverse, don't know about 2nd and 3rd, didn't try...
What are people using for after market or DIY 2G carb air cleaners. Pictures are worth 2650n words. Thanks.
Received my new Champion 2 row aluminum radiator for my v6 225. Direct replacement. Low cost $ 169 delivered. Appears to have good quality. Great...
My original radiator, 17 x 17 x 3 row brass and copper, is shot. $450 to recore. I elected to buy a new Champion aluminum 2 row direct replacement...
This fire wall tag is on my 68 CJ5 V6 225 and all indications concerning the jeep say it is a V6. Any ideas?? [ATTACH]
I talked about this as part of anther thread, but cant find it. Is the baffle that is bolted down with the rocker arm shaft on a V6 225 supposed...
I am confused about the wiring of the starter, voltage regulator, and alternator on my 68 V6 225 odd fire. I have searched this forum and the...
Probably ya'll have made one of these, but I thought I would show you the one I made from an extra distributor I had for my V6 225. [ATTACH]...
Separate names with a comma.