I had the same problem you are describing and I went through all the same checks mentioned here. Mine ended up being worn out clutches in my...
I've seen that 6 before. Was it listed for sale here in NorCal at some point? Nice score, a 6 would be so much more fun to build, that 3 mile long...
Just catching up a bit. Sorry to hear about the divorce, that couldn't have been easy to go through. Looking forward to seeing what this build...
Lol that's hilarious. That is actually a true statement though. I don't know anybody else building guitars with a grease gun.
Turbo? Someone say Turbo? Yes!!! Speed and Power... in my best Jeremy Clarkson accent.
Same here, works well so far.
They are larger than 2 3/4"
This is what I have for pics. I can take others if it would help. I thought it was a front axle out of a 78ish F250 but that doesn't seem to match...
This discussion has me thinking about ditching the #25 seal and letting the gear oil lube the bearings. I think I'll order some more #26 seals...
Forgot to add. These Timken seals #471193 are the ones I am using for the #25. Outside diameter for me is good but inside diameter could be a tad...
Buy a hose with the spring inside and transfer it to the one that fits best, will help keep it from kinking.
I have a Detroit locker and I haven't had any issues with the axles pushing outwards. My axles have a snap ring on the hub side which won't allow...
Do those have the springs inside them?
Yes #25 is the seal I've had trouble with. What is #26?
I have those hubs on my FF and I was getting leakage through the hub and into the wheel bearing. Until I saw your post I always thought I had an...
You say your rear locker is 5:38 and front is 4.27 but they don't typically come with ring and pinion gears on them. You can put 4.27 or 5.38...
That turned out really nice (y)
Should have changed the title to "Trouble 90 to Terrific T18 swap" :D
:watch: Hilarious! I like how Jeepstar is more patient than all of us on this (y)
Tough call. If it were my friends Jeep I feel like in the long run I would enjoy looking at it and remembering the time he put that dent or...
Separate names with a comma.