I assume the "wet look" is a 2 stage (base and clear) vs a single stage (one shot, wet sand and buff) ?
Thanks, I found lots of info about being painted black but no one differentiated gloss vs semi gloss.
Eary jeeps came offthe line with black windshields and hinges[IMG] [/IMG] [IMG] [IMG] /IMG]
I'm almost ready to paint, (66 cj5) should the following items be gloss or semi gloss? Transmission cover plates Windshield frame Seat brackets...
Orange, proby bought it 15 years ago. Replaced it with a 40 ton manley and never looked back.
Just feel the back side of the holes, factory holes were stamped, no burr, if its sharp weld it over with a washer behind it.
The press works well, I had one of the plates shatter when pressing a wheel bearing. I would put them right in the scrap barrel and buy good ones.
You may have had water pooled in the muffler that flowed to a hot part of the exhaust when you bumped the rocks.
I just started the same process with my old k5 that has been sitting since 01. 1. Try turning the crankshaft with a ratchet and socket. If the...
If you want a cheap one I have had one of these for 3 years now and am happy with it for the price. Amazon.com: 100% Original Launch Creader...
Those caged nust for the floor cover pop out, it will be alot eaiser to remove them than work around them.
Mine had alot of extra holes in it, most of them were drilled and not deburred, while the factory holes were punched and smooth. So just by...
[IMG] [IMG] [IMG]
Based on your needs and experience I would go stick. Wire feeds are nice, but if your comfortable with stick just stay with it, its cheap easy and...
I believe it should, my 66 did.
Not the best picture but they mount to the center of the floor, there is a piece of blue felt around on mount in the picture and the other end...
Heres a pic of the drivers seat bracket from my 66. I think you are missing a mount. The seat belts just mount to existing holes I will look for a...
I havent posted any updates in a while, my computer crashed and Io have been working on the jeep instead. Had to machine some puller legs to get...
I just finished the tub last night. The thin layers I scraped but anything over an 1/8" wouldn't budge, I ended up using liquid nitrogen and froze...
Great info, I was going to be looking for these in a couple of weeks.
Separate names with a comma.