I would like to see some photos of the seat base/mounts for a M38a1, with the 15 gal seat tank. I am at the point of needing to fabricate...
I am looking for information on how the stock fuel pickup/sender unit is sealed to the tank. I have an old seal/gasket that needs to be replaced,...
I am using a Chevy Vortec 4.3 V6 from a 1995 S 10 Blazer for my Jeep. In the Blazer the engine ran a remote oil filter, near as I can tell it...
I am getting ready to install the 5 degree shims I got from McRuff, (really nice work BTW) and I have removed the center bolts in each of the...
So what, if anything, are folks using on top of the POR 15 on the frame??? I am looking at just leaving it alone, if there will not be any bad...
I just mounted my hydraulic clutch slave cylinder, from Novak, and I have a question for the collective Jeep mind. The slave cyl has an internal...
I just found this place listed on my aircraft forum. It looks like it may be a good place for Jeep folks to know about also. Sorry if this is...
Mounting a SM465 Questions I have a few questions for the collective mind here at ECJ5. After a bit of searching, I found a few tidbits of info...
I ran across a good source for some of the strange, and unique items used in "specialty vehicles" as they describe themselves. Found quite a few...
I am looking at a set of tires for my rig, 31x10.50x15. Going to be for a stock height Jeep, on and off road use, nothing too extreme----- like...
Here are a few shots of the first actual productive work in what is going to be an extended build. I have spent a few months gathering parts, and...
I finally jumped off the fence about adding a disk brake conversion to my old --D25---front axle, and decided to go with a D30 with disks already...
I want to add disk brakes to my 60 CJ5, but after a lot of education gained here, I became convinced that it would be better to swap in a D30 with...
I am trying to find information about these brake adapter kits, cant find the same unit by searching the net, Google has let me down:( [IMG]...
I am looking at a disk brake conversion for my 60 cj5 front end, and a neighbor has a setup he is willing to sell me. It is not the same kind of...
Anybody use a MegaSquirt setup for controlling a late engine that has been transplanted into an early Jeep??? Are there any other stand alone...
SM 465 trans to a Dana 18 xfr case. Novak, or Advanced Adapter----and why one is better than the other. Or, is there another company out there...
I have decided to go with a Chevy 4.3, instead of the Buick 231, mainly due to parts availability, and age of the Buick. I have just picked up...
Hanging pedals advice needed. I just got a set of hanging pedals, booster and M/C, and clutch M/C from a Wrangler, to put into my jeep. What I...
How do I tell if a Buick v6 is odd fire or even fire, other than pulling the pan and looking at the crank?? Any code numbers in the block to...
Separate names with a comma.