I have this HS9500i from a jillion years ago that has probably cost more than a new Warn. When I first bought it the motor was full of corrosion...
Looking for the following gears from a Dana 18 (large bore case) to make my Dana 20 geared lower. If you have any or all please let me know. I...
After selling my 71 for being too small I was Jeepless. A good deal came around on slightly rusty bucket of a 78 CJ7 and I had to buy. So...
Throwing around the idea of swapping in a front narrow 30. I currently have the stock 27 that I've completely redone but my 33x10.50 rub on the...
Granted my Jeep has some really old gas in it at the moment but its always required a lot of cranking to get her started. Once its started its...
My gas gauge sorta worked when I bought the Jeep but now its totally dead. Thinking of running a wire between the sending unit and the gauge to...
If I install a tie rod flip on my knuckles I believe the joint where my drag link attaches to my tie rod will need to be different. I would think...
Got my Jeep back from the exhaust shop and decided to throw the timing light on just to adjust idle speed. It was way high. I brought it down to...
Pulled the rear bearing cap and old rope seal from the retainer. Problem is inside the block that rope feels awfully smushy. I tried tapping on...
It seems to me I could remove the grille and shroud and leave the radiator in place. Looks like just some bolts on the fender and down below,...
My 71 with rear mount fuel tank had side pipes that have been removed during my Saginaw swap. I will not be going back to side pipes. There’s a...
Getting ready to mock mount my stock steering wheel to my column and I got thinking maybe it would be a good idea to buy a new reproduction one....
I have been trying to find a pitman arm that is as long as the steering arm on my dana 27. I measure 6.5 inches for the steering arm. I can find...
I have my 30" speedway column here and I haven't pulled my stock steering wheel off yet. Before I do that I was curious if anyone could tell me...
I ordered a brand new bestop supertop and they sent it with CJ7 side belt rails. This is the piece on the sides of the tub that locates the bow...
So I purchased the early 70's Pontiac Catalina box. I also picked up a Crown pitman part number J0999416. This arm is for a 72-75 CJ5. It will...
I have gone through pains to get my tcase so dry the drum and shoes have remained without any oil on them (yes the case has oil!). Now I want to...
I was going to use lift shackles but decided last minute to stay lower to the ground. My stock shackles have some wallowed out holes so they need...
For the spring, summer, and fall I would like to put the jeep outside. Since I have no top and the Jeep is really clean I would rather keep water...
My leaves and shackle mount bushings are gone. I see crown sells a set. Some of their stuff is good - some of it is awful. Where do these...
Separate names with a comma.