I have read that the Bestop Supertop can’t be dropped without removing it completely. Here is a link to a guy with a Wrangler that runs a couple...
While doing my 4 speed swap, I really thought I checked to see if the hole in the Dana 18 for clutch linkage was a blind hole or not. Perhaps...
[IMG] I cut the rear driveshaft that came out of my Jeepster Commando to use in the 4spd swap. This is what I found. It looks to be original, but...
With a goal of putting IH T19 wide ratio gears in a Ford T19 case, I haven’t been able to confirm and source the input shaft to adapt to a...
It seems that my steering ratio is too fast. At speed, the slightest steering input feels like too much and is almost scary to drive. If I replace...
Does anyone know what the spline count is on the rear Dana 30 tapered axles? Thank you!
I started to pull apart my right front 10” drum this evening. I pulled the adjuster out to confirm it wasn’t frozen. In doing so, I saw it was...
After reading one of Fireball’s posts, I realized my leaking pinion needed to be reevaluated. I pulled a yoke off of a 4cyl Dana 27, and put it in...
Does anyone know the pressure angle of the gears in the Dana 300? I am hoping to confirm that the input gear of the D300 would be the same cut at...
Hi All, My ‘69Commando (V6 engine+trans donor) drove off the trailer and into the garage. It’s been in the garage for two years. I started it in...
I’m thinking about machining the end of a truck transmission output shaft to that of a T90. Does anyone know if I would need to harden the shaft...
An intermediate fuel tank is going into my ECJ5. The question I have is to the location (measurements) of the filler in the tail lamp panel....
I know these questions come up a lot, but my questions seem to be answered up to ‘62, not ‘64 (my CJ5). With so little left when I purchased it, I...
Hi All, Please point me in the right direction for info. After a week’s worth of looking online, I can’t find what vehicles my manual box would...
I have been interested for a while now in learning how to use a metal lathe in hopes to one day make cool things for my Jeep. That said, I really...
http://www.earlycj5.com/xf_cj5/index.php?media/c262311b-b19d-4a8f-9109-212b32cc60be.6552/full...
Hi All, The lower part of my frame rails are thin from the rear bump-stops to the rear shackle bracket. Should I cut and replace the thin area,...
I have the Jeep builders version of writers block. Why do you folks use swinging pedals? I also can’t seem to decide on GM or Geo disks. I’ve...
Hi All, I have a beautiful Dodge NP435 sitting in my garage. To the people with experience, what are your thoughts in regards to swapping to a...
Hi All, I only have a spall rusty piece of my transmission floor cover. I don’t really know how I should proceed. Do I try to find a repro floor...
Separate names with a comma.