Maybe a valve cover bolt with a extended pin for a spark plug cable holder. :shrug:
I have found that heavy dried and stuck oil and grease deposits can be removed much easier if you have time to allow for soaking. fill a spray...
I bet this was a really fun trip. We have been in this area a few years back camping. New Mexico is one of our favorite states. Often traveled...
(y)(y):clap::beer:, My daughter has her eye on my jeep rebuild, keeps me posted with photos of other jeeps with accessories and colors she likes....
Can't put my finger on it right now but search some more. There should be lots of post here on the subject. I can say your ohm readings sound a...
I am thinking when using a double cardan joint you can use the axle shims if you like to reduce the angle of the driveshaft without fear of the...
I think novak probaby is a good repair kit. They are very easy to work with. However I ordered a full rebuild kit for my t-15 trans and all looks...
yes.
Probaby is your driveshaft. shims under the rear axle may make it worse. Remember the pinion shaft and the main shaft of your transfer case must...
Wow, sure did a good job. Looks like they never missed a speck. I wonder what kind of media they used?
Exactly as Glenn said. I do know that the heat generated on the metal when you blast can warp and ruin a good jeep body. It is not something I...
Have not tried to blast my tub yet, but I have a big compressor (capable of 30 cu ft per minute at 125 psi.) with a homemade air cooler/dryer. I...
New hat channel in and tool box floor going in. I finally learned to spot weld this 18 gauge without burning holes.[ATTACH] [ATTACH] [ATTACH]
Finally got in some shop time this weekend. The new rotisserie I built to really paying off. I cannot imagine replacing sheet metal without one....
I found that if I packed and repacked at home a couple times I would think of ways to substitute items of smaller size that will work just as well...
And I thought it was just me! I think mine usually doubles in size.
I suppose a check for excessive backlash could be done to see if the timing chain has a bunch of slack. Might check the TSM for the specs, no idea...
Self colon scope.:shock:
Humm, not sure but could the valve timing be off/ timing chain jumped one tooth? The ign can be adjusted to be in spec with the distributor and...
Here is how I do it. _Take photo with phone -connect phone to lap top via cable. -phone will ask if it' ok to allow access for connected laptop,...
Separate names with a comma.