Can someone help me identify this Dana 18. , Has an unusually long output shaft cap. Large or small hole? [ATTACH] [ATTACH] Was behind an...
Have anyone used "seam sealer'' of some kind on panel joints? My 74 has a paintable calk or sealer of some kind the factory used where panels were...
Looks like I need a set of new plugs for my 74 AMC 304. TSM says "Champion N12Y'' is the specified sparkplug. However I have never had good luck...
I have a full set of dealer installed molded carpet for my 74 cj5. However it being 48 years old it is in poor condition. I would like to use it...
I need one of those tools to grind, cut, smooth small irregular groves holes ect. I think it is called a drimmel (spelled correctly?) For example...
Just wondering while sanding a spot on my 74 jeep. Is there any chance jeep used factory paint that would of had lead in it?
Well, I was looking over my 1943 MB. I have had this jeep stored in the barn at my mothers old farm stead for the last 40 or so years. I have...
I have heard somewhere it is not a good idea to weld on axle housings with them fully assembled with bearings inside. The weld current passing...
So, I got a parts washer cabinet for free from a guy cleaning out a shop building he had bought. I was wondering what fluid is best used for...
I have gotten a pair of really nice seats for my 74 cj5 from the local pick an pull. They are a heavy cloth/ canvas like material as best as I can...
Any one ever run a sway bar on the rear axle of an intermediate? Can’t say I have ever seen a factory one.
Well, looks like my 304 will be needing a new timing chain. Checked the back lash at the distributor. I am right at the limit. The set in there...
Just wondering if anyone here runs a dual alternator setup on their jeep with an electric winch. If so how about some details please.
Who is running ''Auto meter" 2 1/16 inch gauges that would have an opinion. I have not seen them in person, They look like really nice in the...
Ok, question for all you folks who paint their small parts when doing reassembly work. Parts like bumpers, seat frames, shift leavers, mirrors and...
My 74 with the 304 V-8 with the factory distributor uses a ''resistance wire'' in the wiring harness from the firewall connector plug to the +...
Well I have all but given up on finding a good used windshield frame for my intermediate 74. looked at 4 used ones for sale around and none of...
I was just doing some research on installing my new YJ springs, poly bushings and hangers. I read something about the new poly bushings needing a...
I have been researching which welding helmet to buy. I see that I certainly need one with auto darkening. I also see most of the better helmets...
Just looking at my 74 windshield frame and wondering what one is to do prevent further rust on the inside of the tube where there is no access for...
Separate names with a comma.