Not sure how this could be measured or calculated, but I’m curious how tire size affects “crawlability” one of my other hobbies is mountain...
Basically a large set of pliers with a thingamajig welded to one of the jaws to bend the rivets:...
That gauge cluster looks in oddly good condition considering the rest of the vehicle is literally crumbling back into the earth.
The longer you stare, the worse it gets.
Here’s what I do from my iPhone. Not sure if iPad is the same: - click “upload a file” -click choose file and then photo library if using an...
PO had installed a hanging pedal of unknown origin. I removed the pedal from the arm and installed a skateboard bearing at the end of the arm,...
I installed a locking throttle knob in the dash just below the speedo. It has a stiff wire that runs to the back of the engine, and then it’s...
Listed two years ago… I wonder why it hasn’t sold:confused: [ATTACH]
I always tell my wife “on the bright side, at least I’m not an amateurcrastinator!”
Having an arm that’s the correct length, drop and taper is 99% of the way there. Personally i would keep that arm and file splines into the...
Whoever buys it will be saving a lot of money on birth control.
I’m pretty lazy when it comes to cleaning vehicles. If the Jeep has been sitting a while, I’ll blast the interior with a leaf blower. And I...
Anything newer than 1975 needs to be smogged every two years in California. Makes a late 70’s vehicle undesirable, IMO. seems like it would be...
Sounds like something wrong with the wiring. If I had to venture a guess, i would check the exciter wire. Other culprit could be too small of a...
I’m on a Jeep JK forum where a member said someone reported his hood mounted high-lift jack to the police, because they thought it was a machine...
As long as you’re not concerned with originality, it’s not too difficult to make something that will work. [ATTACH]
“When the choke is closed it is running at about 600 RPM if that matters for this.” that’s likely your problem. With the choke closed, your idle...
Either that, or his wife wanted him to sell and he “can’t figure out why it isn’t selling”
Looks better than any of my jerry cans. If there is a hole, you could put some duct tape on the outside to act as a dam, and then use por-15 to...
I’d recommend following these adjustment instructions to see if that fixes the problem...
Separate names with a comma.