with wheel well headers, used to exit in front of the rear tires...too loud, now routed out the back.
they are a great look...enjoy
When I purchased my 71 CJ5 (new) and drove it off the lot I was pleasantly surprised when my RPM seemed quite high...when I got it home I...
back to original fuel and temp gauges for me.
When I took my Jeep to Israel in 1978 the clutch cable was one of several, not expecting to find and needing immediately, items I took with me....
Very nice jeeps. My 71 CJ5 has been my only jeep, bought it new in late 1970. Within the first week I had the warn overdrive in and with the...
Thank you friend
what great memories you have and thanx so much for sharing. we older guys can relate to those simpler times.
ditto! bought my 71 new with 4.88's and after about a week I put a warn OD in. excellent combo for crawling and freeway.
Hello, I like Ed share an experience of driving my jeep in the Med and Red Sea areas in 1978. Well over 120 F when there and used Penzoil 30W...
howdy, yea I did it differently on my 71 but I use wheel well headers on my replacement Buick 231. So the natural placement for the mufflers is...
Since I bought my 71 new I thought I would look at my vin tag...its 3654xx so a little earlier than this one.
really nice information, thanx for sharing this. One interesting item I have always had in the back of my mind since I purchased my 71 new in...
This product will allow you to reduce or advance your speedometer in small percentage increments... *GM / Dodge / Ford, Ratio Adapter, Select...
my 71 did not have "JEEP" on the side by the V6 emblem, painted different than the vehicle from the factory...maybe because it was white?
Realizing this thread is old I am commenting anyway, I as well am encountering issues finding a temp sending unit for my factory original SW...
both gauges work beautifully with the 7806 regulators...10 ohms for full, 25 ohms (I have a 0-25 ohm potentiometer) about 5/8 full...wonderful,
[ATTACH] Okay, curiosity got the best of me, I opened my fuel gauge as the resistance measurements were not correct AND I wanted to know about...
okay, thank you, thought this was the case. One possibility in diagnosing the gauges is what was mentioned above...either the needle is being...
oh, okay. I was under the impression both gauges were 5-6 volt and could be damaged when/if the ground was compromised to the cluster. If the...
Separate names with a comma.