okay, that makes sense. Thanks for the help guys.
Okay, kind of a new guy question. I am rebuilding my fuel system in the ‘51 M38 and am going with a Holley Mighty Mite electric fuel pump. My M38...
Found mine on eBay. All original and had the correct mount and bracket.
Nice!!
Not to hijack this thread, but how do you guys drain your radiator? Last time I did it, I loosened the small release valve at the bottom. No quick...
Thanks for sharing that Mark. When I replaced my crank pulley I was more concerned about pulley groove size and alignment of all the grooves/belt....
Thanks but I think that’s the water pump pulley. But I appreciate the help. I did get a new crank pulley and got it installed a while back, seems...
Thanks guys!! @CHUGALUG can you describe which riser and a little more detail about your suggested path? I’m also trying to find where the...
Hey Mark. No I think the setup is great, I think electric fuel pump is the way to go, and am not sure the regulator is needed either. My guess is...
Hey guys. The previous owner did a great job getting the fuel system up and running when he pulled the M38 from a barn last year. It runs strong...
Pics! Post a few, maybe we can help.
Okay, thanks for backing me up guys. Just wanted to make sure I wasn’t about to do something really stupid. I just added oil and fired her up...
Hey guys, another rookie question here, but I want to be sure I don’t hurt anything serious. I just got my new crank pulley and timing cover...
Absolutely! Good advice!
Pulley is off! 15 seconds with the torch (on the pulley slot area) and under tension with the puller… came right off. Finally!!! Good points...
Cover is off. I’m attempting to “dry fit” the offending pulley before re-sealing everything. I’m thinking too that I need to get a torch and heat...
Thank you. I got a pulley puller and got it off, then started filing and prepping both the key and the pulley groove… and now the pulley is stuck...
Hey guys, I removed my grill, and radiator and got the old bent crank pulley out. Cleaning up the TC and got my new seals, etc. Here’s the...
Update: I tried a different horn I just received in the same setup... and it’s works perfectly! I’m not going mad after all! I’m guessing the old...
Thanks guys. I’m also starting to think I might need a horn relay, as the button/switch may not be able to handle the power load. But even when I...
Separate names with a comma.