Roughly, how much did that set you back ?
Unfortunately I am using Herms axles but should be ok. I am very light footed and have never broken a stock axle Even when I ran 36" tires.
My shafts are polished but none of the seals are quite the right size. I will look into the Seal-it seals.
I am reusing the R&P and have located a set of bearings. The only thing I have left to figure out is what size axle seal I need. The 30 spline...
Thanks guys, I give that a try.
I have 30 spline Truetrac and 30 spline axles. My only problem is finding carrier bearings to fit the Truetrac. I know it can be done just not...
That is exactly what I have. I know guys smarter than me have done this but would really like to know what bearing they used.
I am currently converting my 2 piece Dana 44 to a full floating axle. I finally have gathered up all of the parts and thought that I was ready to...
I really do hate Bed liner unless it is in a pickup bed but I am fixing up an old Meyer top and got to thinking. I also hate how loud metal tops...
My pictures suck but what I did was make a simple bracket for the slave cylinder that attaches to the inside of the frame. The other end of the...
I did. I used Wilwood parts and used a chain attached to the stock turnbuckle. Was pretty simple and works great. I will try to get you a picture...
What kind of insulation do you have on your roof ? Going to recondition my top soon and want something to dampen the noise.
Not sure you can get the field coils out without a poleshoe vice.
If you have an ignition switch with an accesories post you can run your #2 wire to that post and it will stop feeding back to your ignition.
I built my own toy hauler out of a 18' V-nose cargo trailer. It is a heavy duty H&H that can haul over 7000 lbs and the ramp handles 4000 lbs. I...
[ATTACH]
[ATTACH] My in cab controls. [ATTACH]
Got it rebuilt and installed. [ATTACH]
Try it and see what happens.
You can buy that same alternator on Amazon for $80. Search for "10SI self exciting alternator". I doubt if you will need the wide pull that...
Separate names with a comma.