I apppreciate the advice. I think that I could have done a better job with the seating process, and hope it's not too late to re-do it with the...
My wife and I spent the weekend with my daughter in Denver, but the flight landed early enough to get a little work done. I completed pedal...
So the paint over the bedliner didn’t work. It is still tacky after about 3 weeks. I think the solution is going to be mostly mechanical removal...
And a first draft for the bracket for the clutch spring based on @Fireball ‘s photo. [ATTACH]
First draft. This is not the spring I am going to be using, just one to help figure out how to cut the boot. [ATTACH] [ATTACH]
How did you teach your dog to drive stick?:D
Some tricks just aren’t in the FSM! Thanks again. Kaiser Willys has 2 different ones - one is for a 3 3/4' square opening. The other fits my opening.
I flipped it around, but that blocks the return spring and clutch cable. @Fireball ‘s looks like there is a flap where the cable attaches. Is it...
I disconnected the cable and removed the boot and it moved much more. [ATTACH] My two issues right now are figuring out the proper orientation...
And maybe my second duh moment - I think the rubber boot for my clutch fork is backwards.
Thanks. I read that thread and it started me thinking, which may have led to a duh moment. The only things I changed are new Luk clutch, Luk...
The other update is that I do have a small leak from the part of the TC that had the crack as predicted by @Andrew Theros. I think I might be...
Here’s the bummer. I have tinted bed liner on the bottom of the tub. It didn’t have quite enough color, so I went to my paint shop, told them what...
I started reassembling the pedals. I need to retap the grease fitting for the brake. [ATTACH] The clutch doesn’t have much travel. I have a...
Few steps forward, one big step back. Stripped the paint off the headlights, cleaned them up, and ready for assembly. [ATTACH] Cleaned up the...
I took all of the slack out of the clutch and put a pipe over the clutch are and was finally able to push in the clutch but I still couldn’t get...
Still need to fire on some clear coat and there is still blistering on the back side of the headlight rims, but a lot better. [ATTACH]
Here is what I have right now: Tranny - 2nd gear TC out/high I cannot roll the jeep front or back. When I push the clutch shaft forward, I still...
I will try that tomorrow. I can do this even through the engine isn’t running, correct?
I just installed my clutch pedal and did a “dry test” to look at the travel of the pedal. It is a new clutch, but the AA chain system and pretty...
Separate names with a comma.