OK guys. Thanks for the guidance/advice. I am a complete chicken so I went for a brand new replacement for the AMC 20 to include the hub axle...
Ogre, you are exactly right. AMC 20 not the Dana 30. Typing too fast and not paying attention. Appreciate the correction and the guidance. I have...
...now I am getting gun shy....UGH!!...should i just find the original Dana 30 and put that on for simplicity?... What would you guys do?
OK...I already have the 8.8 (actully have the entire rear end)...and i have heard of CJ guys making this same swap...and the axle is stronger than...
Hey guys! It has been quite a while since my last post/question. Its good to be back. Anyway, I shredded an axle pin on the rear axle. So, why...
I can't figure out how to upload some pictures to this thread so you can see it. Do you know how to do that?....or I can post some on my blog and...
LOL.....Of course it does, Pack. Speaking of Commandos, I located yet another one here locally. It is a '68. It is with its original owner with...
LOL......to funny, Pack.........how you gettin' along on the '71 Hurst?
Everyone I have FINALLY added another update to the blog. :driving: I have new pictures and have also updated the "Costs" page. Go check it out...
You all are great! I'll take all the guidance into consideration. Thank you!
Hey Guys and Gals! Where can I find a new wiring harness for a 1967 Jeepster Commando? Thanks, JL :v6::flag:
This is good stuff, SMIGGLEY! Thanks! :flag::v6::beer:
Well, it has taken me a couple of months to get to this, but here it is. :beer: 8705F1615312 :v6:
OK Gang! I want to replace my front and rear axles with Dana 44's with disc brakes. What vehicles would I look for to find these for my...
This is good stuff, Psychojeeper! I appreciate the guidance and will adjust my plan accordingly. Thanks! :beer:
Thanks, Warlock. I will take all the advice and recommendations I can get. :beer:
Thanks Wolfy! Appreciate the advice. :stout::v6:
Thanks for the info, 60sCJ! :beer: BTW everyone, I updated the blog. Go check out what I have accomplished this week! Pics are included!...
Hey, Trick. I appreciate the feedback.......as always. Anyway, on the 4" lift you mentioned Alcans. Is the website www.alcanspring.com the right...
I am not sure. But, Packrat and trickpatrick are both great resources. If you guys read this. Can you chime in on this question. :v6:...
Separate names with a comma.