1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Removing Clutch fork without disconnecting Transmission

Discussion in 'Early CJ5 and CJ6 Tech' started by erhuff, Aug 10, 2012.

  1. erhuff

    erhuff Western MA

    I have read differing arguments with this. I am going to side with those who say it is possible, mainly because I want it to be possible.

    How did you take it out, then put it back in?
     
    erhuff, Aug 10, 2012
    #1
  2. piffey263

    piffey263 Active Member

    well I know on my jeep you can if you unclip the throw out bearing and then the fork will slide off the pivot but I don't recall if the hole in the bell house has enough room.
    However to put it back on I would want transmission off and such.
     
    piffey263, Aug 10, 2012
    #2
  3. Warloch

    Warloch Did you say Flattie??? Staff Member

    eh - no - not gonna happen - been there - dreamed about it - the two boys fiddled with it for 4 hours - ended up pulling the whole deal just a month ago or so.

    I am not sure if I want to know if it really works... part of me wants it to - the part that already pulled and put things back does not :D
     
    Warloch, Aug 10, 2012
    #3
  4. chuck123wapati

    chuck123wapati Member

    besides the throwout bearing usually goes out why would you need to pull out the clutch fork without the bearing?
     
    chuck123wapati, Aug 10, 2012
    #4
  5. nickmil

    nickmil In mothballs.

    Knowing what engine and transmission Would be helpful to answering these types of questions.


    Sent from my iPhone using Tapatalk
     
    nickmil, Aug 10, 2012
    #5