1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Dauntless block huggers

Discussion in 'Early CJ5 and CJ6 Tech' started by cj-john, Dec 18, 2010.

  1. cj-john

    cj-john Member

    What I really need is a set of :v6: block hugger headers. That would be sweet! Any idea if anyone builds these? I might just buy a bunch of bends and build a set this winter.....
     
    cj-john, Dec 18, 2010
    #1
  2. Warloch

    Warloch Did you say Flattie??? Staff Member

    Warloch, Dec 18, 2010
    #2
  3. cj-john

    cj-john Member

    Very nice Warloch. I appreciate the link.
     
    cj-john, Dec 18, 2010
    #3
  4. cj-john

    cj-john Member

    Hey Chuck, I see Sanderson offers a set of block huggers on their site. Part # BS1-P. Are these the same headers? I don't see a part number or a price on Novak.
     
    cj-john, Dec 18, 2010
    #4
  5. nickmil

    nickmil In mothballs.

    Did you contact them directly?
     
    nickmil, Dec 19, 2010
    #5
  6. Smokeater

    Smokeater Sponsor

    Under the picture, click option I Or II.

    #BV6 $275
    #BV6C $435
     
    Smokeater, Dec 19, 2010
    #6
  7. Warloch

    Warloch Did you say Flattie??? Staff Member

    The Sanderson is not the same - the ones from Novak have been messaged to work with stock and thier motor mounts, clear for Saginaw Steering (make it easier to install), the starter has better clearance, and the dumps have been shortend to make it easier to run the exhaust inside the frame above the cross member.

    Oh - I have to use Firefox as their web person didn't make things compatable for all browsers... I won't even go thier as a software developer (past) and Data Architect (current)...
     
    Warloch, Dec 19, 2010
    #7
  8. electricontr

    electricontr Member

    I see them on ebay quite often.
     
    electricontr, Dec 20, 2010
    #8
  9. cj-john

    cj-john Member

    Thanks guy, I'll check em' out.
     
    cj-john, Dec 20, 2010
    #9