Yeah, it ain't no fun, especially breaking that rear stud. Stainless studs sounds like a good idea, where did you get them?
We mostly drink corn whiskey down here in the South, that brown stuff will get you in trouble. Even so, I only use non-ethanol 100% gasoline in...
Yes, as Jw60 says use studs, and coat the threads going into the block with sealer, I prefer Permatex. The sealer does two things, it seals the...
Ken, I saw at least one good "beehive" glass in a box full of old lights out in the shed, may be more than one. There are bases and other parts...
X3 on E-Gas. I avoid using that stuff on anything that may sit a while between use, and never put that crap in the tank of my Jeeps unless there...
I can't help you, other than to point out you posted this in the wrong section of the forum. You might get better responses if you post it in the...
It is a good feeling to get to this point. You did a lot of work in a fairly short time. Good Job!
I have a MTS plastic tank in my CJ5 which I installed nearly two years ago. The gas cap has always been a little difficult to lock, and the...
As Rick on Pawn Stars says, being rare doesn't make something valuable.:cry:
Herm rebuilds overdrives, he does not make them as far as I know. Shims are not uncommon in rebuilt gear boxes of any kind.
He has a thread on the CJ2A page forum under member created parts, which you can view even if you aren't a member over there. He lists his contact...
Getting ready to rebuild one myself, and will be buying parts from "Vintage Jeeper" for the job. Sal also sells a dummy shaft for preloading the...
Last Saturday I pulled the transmission and transfer case of a CJ2A, not because of leaks, but because they needed replacement. Both did leak...
The transmissions are bad to leak from the front input shaft seal. This would cause transmission oil to drip out of the weep hole in bottom of the...
Problem with his test set up is these pumps are really designed to have fuel gravity fed into the inlet before it can really "suck" any fuel. So,...
Separate names with a comma.