I have 362017 and 362023. Both Prairie gold Renegade 1's built October 1969
The forward "straps" share the body to frame hole. In other words it goes through the bracket- through the floor and into the frame.
Well I looked through the photos I had taken when pulling it apart and only could find this one of the rear. I do have the seats but they are not...
So I have had some time to compare the two side by side so to speak. The major difference I see is the axle gear ratio. The new one is 3.73 with...
It runs! Been a long time since I heard it running. Still need to do some tuning but will worry about that after I get it full assembled. The next...
Update, The wiring harness has been modified and completed to match the original and installed, just finished rebuilding the distributor. By the...
So I got to dig into the new R1 a little more this weekend. Found some good and some bad things. Trans and t case are definitely shot as the...
Warloch; You guys just have nice stuff out there, couldn't pass this one up. Zoomer; yeah it was too tempting, luckily the guy agreed to hold it...
Plans are to use the bits and pieces needed to make Gramp's R1 a 100% restoration then go through it and inventory what is there. Will re-assemble...
Monday Aug/10th Seattle Wa. The day started off like any other morning, checking EWillys and ECJ5 to see what is new. Looking in the...
Wow I can't believe it's been another year since I posted any progress. I have been busy on the Renegade in between side projects for clients. The...
Yeah it should be a V6 box but all the measurements i get off of the shaft show it to be a standard box. Easier to get parts I guess but a little...
So I got into the Ross steering box this weekend figuring i would probably need to fix the pins on the sector shaft and found this. [IMG] [IMG]...
No I didn't have the block "professionally" checked out but it ran fine and had good compression when I tore it down. My Dad and I have rebuilt a...
Separate names with a comma.