"I'll give it a go on the old southbend." = "I'll try to make the correct gear on the South Bend lathe."
What's wrong with your English? It's better than the average US college student.
Right. Got the paperwork but not the merchandise.
Assuming the clearances are set cold, the intake would require more clearance because the push rods will lengthen (.002"?) when hot and use up...
Try a magnet. Some SS alloys will hold a magnet, others not. So if a magnet won't stick it's SS. If it will stick it could be either.
I'm not getting this. Did you mean to say the tips of the blades …?
Not making any claims here, and not intending to hijack the thread, but just for fun, my Unimog's Super Crawler low gear ratio is 283:1. It's been...
You can get the degree mark (°) by holding down the Shift and Option keys while pressing 8, thus: 2°, 7°, 32°, 212°, etc. This on a Mac. I'm...
Only nine years ago, and you don't remember it??
Separate names with a comma.