not sure what u did, but i have one.
If you havent passed this on yet MAKE SURE rebuilder understands how to leak proof it. info is on the website.
dont chuck ANYTHING.
Been working on a shroud for my cj5 V6. The one pictured is my prototype and made from 3/16 paneling glued and screwed. Hopefully I will refine...
JW60, How has this worked out for you?? The new baffle looks like a bear to bend. Do you have a water flow shut off valve so u can get freash cool...
I have resisted in the past, but I'm getting older and this was probably my last chance to try this. I'm rebuilding my T90 shift tower, putting...
Yes I ended up tearing the T90 tower down, detent ball springs were stretched by PO making shifting very hard. I took out the 2 to 3 shift fork...
Glenn, Not a big deal to me. What I found was loose pin installed to hold shift fork to shift rail allowing the fork to wiggle around. I sent my...
I'm going to contact him about it.
SILLY QUESTION, BUT I DIDN'T SEE IT MENTIONED. IS #1 PISTON ON COMPRESSION STRIOKE AT TDC??
OK, OK, I owe everyone an apology for the above post. I limited my T90 shift tower rebuild research to this forum only. I'm a little rusty in my...
Separate names with a comma.