Hi all, I am rebuilding the Dana 18 and I have it all put back together EXCEPT for the rear bearing cap. I cannot get any play out of the shaft to...
Hello there! Looking to sell a rebuilt Dana 18, its an early 50's small bore, 3/4" intermediate shaft version. Twin sticks, very smooth. I can...
Hi everybody! Trying to button up my Dana 18 to finish my clutch replacement turn T14 rebuild. All 4 corners of the D18 pan gasket blew out....
I just finished rebuilding my TC, but it will not be installed for a long while. Any ideas how to go about storing it? Dry, with fluids...? Any...
Where can I find a Dana 18 shim set with different thicknesses? All the sets I've found are all the same shims. I would get that as you fine-tune...
Does anyone know if there is a difference between the shift fork for the front axle with part numbers 18-66-7 and 18-66-8? I need to replace mine...
I got a chain clutch control assembly, has anyone used one or installed? I’m interested in if I wasted my money! I also have a Muncie 465 and...
Separate names with a comma.