Roxor Parts Swaps

It bolts similarly to the frame. Should be very adaptable. The shafts and rods should be about perfect length OoB too.

Do you have a NT30 or 25/27?

 

I'm on board here for a clutch/brake pedal "upgrade"; waiting to hear from a local dealer if that's how it works.
dne'

kind of excited to do away with this:

 

Dgroshek has some pictures of his Roxor pedal install on page 4 of this thread: Roxor - Swing Pedal Assembly

Looks like a nice setup, also includes a hydraulic clutch.

 

Thank you Fireball!!

 

I have been looking into this and running the 44 upfront too disk brakes and a bad *** front axle for right at a grand is an awful good deal.

Also trying to figure out if the rear drum setup will work on a cj as it would allow removal of the t-case parking brake.

Those things along with the swing pedals would be a huuuge uphrade to these old jeeps

 

Question on the roxar pedal set up. How does the pedels follow the contour of the floor on the pre 76 jeeps?

 

The Rox floor is shaped similarly but I’d have to see a picture.

 

Put the pedals in my Jeep. The Roxor has a flat plate that bolts up to the firewall. I had the top of the plate against the cowl. On the right side the plate was against the roll in the fire wall.

 

I'm excited to install my swing pedal parts when they arrive. The little wheeling I've done has shown that my frame flexes enough to bind my pedals. Not acceptable, IMO. This'll be a good upgrade, I think.

 

These seats can come in a CJ5 without problem ? You can tell the facts ?

 

Here is everything in one place.

Roxor - Seat Install

 

Anyone tried mounting one of these center consoles in a '5?

 

No but that does look simply and nice

 

Just looking at it, it looks too wide for an early CJ5.

 

I have one (not installed). I can lay it in my 5 and see. My seats are not stock though.

 

Would give us an idea. Maybe measurements or mods that may have to be done.

 

Doesn’t seem like it’ll fit.

 

Thanks for checking! Would have been really cool

 

Has anyone seen the ventilating windshield on the Mahindra Thar? I seem to recall that our early/intermediate windshields would directly swap into the Roxor, is this correct?

There's a fun thread going on in the expeditionportal forum about mahindra stuff for jeeps, and this pic was posted:







It got my wheels turning; if we could import some of these parts, is this a potential solution to the ventilating windshield problem?