Rock Sliders/steps

I have two sets of these in stock.

3/16" Thick Angle 2" under body, 3" on rocker side.
1-1/2" tube, .120 wall.
Coated in fluid film to prevent rust.
Yup they are heavy.
$180 per pair plus the ride to you.

This is an advertisement for a pair of brand new, un-installed, no holes drilled, bare steel sliders/steps.
Jeep in picture is not included with sliders.
These work best if you bolt through the rocker and through the floor board. I pre drill holes in the angle, then using a floor jack and block of wood drill through the rocker/floor board.

 

Those look good!

 

PM sent

 

Nice!
Want to make a pair for a 2004 Wrangler??

 

Love mine! (still need to add the remaining fasteners)

 

Have you ever made a pair for a CJ-6 ? I'd be interested.

 

I'd take a set too for my CJ5.

Would you make some for a flatty?

 

Those would be cool without the tube work, just the angle iron, kinda stealthy rock sliders.

 

I would a pair work on a CJ3B? How long are they?

 

Pm me the overall length and I can see what it would cost to build the same slider but longer.

 

I don't think that these would be well suited for a flatty because the rocker panel is not straight.

 

Hey Norcal, steps arrived looking great! You do fine work! Thanks again

 

Very Nice work.

 

i have some angle iron, might try that.

 

I have 4 sets on order that should be available soon.....

 

Any idea cost to ship to 85383?

Richard

 

$40

 

I too am very interested in a CJ6 set. Where do you want the measurement from? Front tub/fender seam to the corner of the rear wheel opening?
Frank

 

Yes, from the crack where the fender meets the tub... to the rear wheel opening, about 3" high up from the bottom of the rocker.

 

On my 75 CJ6, that measurement is 62".