Midwest Military - Welcome to our Store - Midwest Military Store has them. $1 for a bolt and $4 for the clip. The M38A1 shares the same part....
I'll have to keep an eye on this thread. I'm planning on doing a bikini top from Beachwood for mine (they have the template and make one). I...
What is the correct bulb for the light?
What type of glue or adhesive are you guys using to affix your trim tag like this one: [IMG] I have yet to put mine back in place as I'm unsure...
What is the correct size / pitch bolt hardware for the step mounting?
I'm aware of that bracket to the frame, I'd still like some locations in terms of dimensions for the holes in the body. I get the general...
OK, I've got my steps all painted and ready for install. My floor pan has been replaced so the original holes aren't present, neither are the...
LOL, oops. You can tell I have a Ramsey :banghead: This may be more helpful Willys Winch
Hi Bob, we may need a bit more info to answer your question. I'll take a stab at it assuming you have a single stick PTO. The transfer case...
Yes I do. Oh man, I feel like an idiot. I just reread the section. It's clear about the jet being in the block. I'm sure mine has the right...
Sigh, I checked the orifice on my filter housing and it's .070 or at least its bigger than .040. I'm somewhat confused - is the right orifice to...
To close this out, the D18 twin stick boot seems to work perfect after you trim the round base a bit.
Anyone shoot a picture and get me some info?
The engine was rebuild in 08 so the warranty is done now. I was more concerned about any damage to the bearings. I talked to both Midwest...
I knew my simple question would start a big hubbub :whistle: At least I know my oil pressure is good. The only reason I brought up that part is I...
Separate names with a comma.