4WD Hardware fenders

Has anyone had any issues with the fiberglass fenders from them?? I'm sweating over a possible problem with them being out of square where they mate to the tub. When bolted to the tub, they slope down towards the front where they mount to the grill. Should'nt they be on the same plane as the tub sides???:? :? I've got a call into the tech deptartment now to see what they can offer. Any thoughts??????

 

I've had some on my CJ for quite a while and they line up just fine. Make sure that the rubber mount under the grille shell is the same as the body mount thickness. If you did a body lift without doing it to the grille, it would cause misalignment. You could always raise the grille with additional spacers to get the alignment correct.

 

Thanks for the reply Rick. I spoke with the tech guys at 4wd and they were not aware of any problems with the fenders. I looked at a few photos they sent me of other fiberglass projects, and all the fenders sloped alittle to the front. I assumed that the fenders would be flat level like the body and they are not.